PSDPlayer
05-27-2007, 05:29 PM
http://www.gogodiesel.com/forum/photopost/data/500/BL505D-AB.jpg
GoGoDiesel picked up a new brake lathe this week. This brake lathe uses a machinist type cutting head to allow the cutting of cross-drilled and slotted rotors. There is no better machine on the market. This will provide a higher quality finish than any Ammco brake lathe that most dealers use. If anyone in the Ft Lauderdale area needs brakes give me a shout.
GoGoDiesel picked up a new brake lathe this week. This brake lathe uses a machinist type cutting head to allow the cutting of cross-drilled and slotted rotors. There is no better machine on the market. This will provide a higher quality finish than any Ammco brake lathe that most dealers use. If anyone in the Ft Lauderdale area needs brakes give me a shout.