5 inch replacement tailpipe

[Santa Gertrudis]

Guys, I need to find a 5 inch tailpipe section. Does anybod sell just the tail section? Thanks

[banksforddiesel99]

you mean because you cut yours off? if so, just find a 5" to 6" stack, and trims your back a little bit further and make that beast fit in there, it would look awesome!

[PSDPlayer]

I have a contact that used to work at silverline. I wonder if they have anything available.

[6L strokin]

i made my tailpipe out of a couple 5" elbows, couple people have seen it and told me it looked better and the placement was nicer than some companys kits...

[Santa Gertrudis]

Where did you get the elbows?

[6L strokin]

local big truck place....Auto Wheel & Rim. i think i ended up using 1 90 degree, 1 30 degree and 1 37 degree maybe......and that made it to where the 30 degree went up toward going over the rear axle, the 90 made the loop over it, and the 67 came out under the fender just right (look at my pic on the side to see how it came out) which i think looks better than some 5" kits that end up pointing way down toward the ground....

[janamarie]

Guys, I need to find a 5 inch tail pipe section. Does anybod sell just the tail section? Thanks

I know this was ages old, but i am helping my friend on locating 5inch tail. Have you found one? or any sites that might help on this? thanks.

[!!!PainTrain!!!]

Are you talking about from the muffler or CAT back? Just about any exhaust manufacturer sells a CAT back exhaust system in 5"

[janamarie]

I know this was ages old, but i am helping my friend on locating 5inch tail pipe (http://www.car-stuff.com/tailpipe.htm). Have you found one? or any sites that might help on this? thanks.

I am talking about the cat back exhaust. Any way i saw one site that has this but a bit costly than some autoparts store price.